Enrico di Maria, Giulio Reina, Kazuo Ishii, Nicola Ivan Giannoccaro
Journal of Terramechanics, Volume 97, 2021, Pages 59-70, ISSN 0022-4898
https://doi.org/10.1016/j.jterra.2021.06.004.(https://www.sciencedirect.com/science/article/pii/S0022489821000574)
Abstract: In this study a 2D FEM model was developed to analyze ruts formation, rolling resistance, and power loss for a grape transporting cart aimed to replace the use of heavy tractors while harvesting grape. The model was supported by experiments in a vineyard in South Italy. Cone penetration tests were conducted to estimate frictional and cohesive properties in three soil conditions: firm, soft, and wet saturated. A tractor pulled test rig for a single wheel was developed to measure rolling resistance and sinkage, and complete the selection of the soil parameters. Completed the model, the analysis was conducted for a range of different wheel dimensions, and the outputs analyzed through response surfaces. The results showed the different impacts that width and diameter have on ruts formation and rolling resistance for different soil conditions. Wider wheels determined a main reduction of the sinkage, while the width contribution to the rolling resistance was affected by the total soil volume deformed. Larger diameters led to lower rolling resistance, with a higher impact on more deformable soils. Contact stress was compared with the thresholds recommended in the literature to determine the acceptable designs. This analysis represents a tool to select the running gear dimensions.
Keywords: Cone penetration test; Pull test; Resistance coefficient; Rut formation; Response surface; Vineyard